If your Samsung phone is stuck on the FRP lock screen, then you can try different methods to bypass the Samsung FRP lock. But it is not necessary that the entire Samsung FRP trick will work for you. If you have a Samsung combination file [pre-enabled ADB file] on that condition, you can easily open a factory binary on your device. In essence, you can enable USB debugging and OEM unlocks FRP Lock Samsung mobile.

master education online

How to download Samsung Combination Files [ADB file]

If you are trying to bypass FRP Lock using the Samsung combination file, first you have to download the Samsung combination file for your mobile. you can Download free combination files

How to Flash Combination with Odin Flash Tool

We will show you how to use the Odin tool to flash the Samsung combination files, and how to bypass the Samsung FRP using the Odin tool without the downgrade Android version.

Prerequisites for Flash Samsung Combination File

Download the Samsung combination file according to your device model number.

Download Samsung Combination File Flash Tool -Odin F

Download Samsung Firmware for your device –

Download Samsung Drivers – Samsung USB Drivers

Now if all the above files and tools are ready then go ahead and read all instructions carefully.

Stock Firmware Galaxy Note 8 [BL, AP, CP, CSC, UMS] Download All In One

Enable USB debugging by flashing the combination file

Remove the downloaded Samsung combination file, if it is in zip format. [Combination file should be in .tar format]
Turn off your device and boot into download mode.

[Once you press the Volume Up Key alert message, press Volume Down + Home + Power Key simultaneously and press]

Plug devise with PC via USB cable.

Run the Odin flash device as admin on PC. If the device is connected properly, you will see “added” in the Odin tool window.

Navigate to the “Options” tab and configure the tool shown below.

Click on “AP” or “PDA” and browse the Samsung Combination .tar file and wait for it to load.

Finally hit the “Start” button to start the combination file flashing process. The end of successful Flash, you can see the green “pass” message on the screen.
Now the phone will reboot automatically and boot into factory binary mode as shown below.

After the full reboot, the screen of the Samsung device will be as shown below the screenshot.

From here, the phone that opens “Settings” enables USB debugging and OEM to unlock from the developer option. [If already enabled, skip step]
Turn the device off again and go to the second step.

How to bypass google account BQ Aquarium U Light Android Version 7.1.2

Phase 02 – Flash Official Samsung Firmware

After flashing the Combination files on the locked Samsung phones, this will unlock OEM lock and USB debugging. So now you are ready to flash official stock ROM to remove Samsung factory reset security.
Note: Make sure that you have downloaded the correct official firmware for your device. Do not flash non-supported firmware

Turn off the device again and boot into the download mode again using key combinations.

[After watching the warning message, press Volume Down + Home + Power Key and press Volume Up Key to boot in Download Mode or Odin Mode].

Unplug it and insert the USB cable again.
Now click on AP and browse AP file with full firmware.

If there are many files in the firmware then browse the “BL” file, “AP” file, “CP” file and “CSC” file one by one)

Hit the “Start” button again and then flash the official firmware device.
After completing the process, the phone will reboot again and you can remove the USB cable.

The device will take a few minutes to update all the software on the device. Sit back and wait for the reboot automatically.

Leave a Reply

Your email address will not be published. Required fields are marked *